Engine power: Bimotor
2 Hp 1.5 kW 400Volt 50 Hz. (Hydraulic motors)
2 Hp 1.5 kW 400Volt 50 Hz. (Cut engine)
Minimum: 600 kg / hour
Maximum: 800 kg / h
• Width: 650 mm
• Height: 1300 mm
• Height: 1055 mm
Net Weight: 252 kg
Square blade bed dimensions: 6.5, 14, 22, 29.5 mm
Except flaked meat cutting machine, potatoes, cucumbers, carrots and so on. hard vegetables like can also be used in cutting. The hopper is filled with meat or vegetables thanks to the blade system on the machine's hard-body case of meat flaked off outlet chamber parts are made of pre-cut lengths with a cutting blade length.
Blade system of flaked machine up and down and moving right but also the right and left, makes the driving piston forward cold meats in the right bass that chamber and rigid-body cutting height With pre-cutting blade cuts the extent required vegetables.
Boneless meat of temperature 0 and the hopper to be filled - must be between 5 degrees.
External housing units and all fittings and equipment in the 304-quality stainless steel.
There are a minimum of 90 x 90 mm square blade on the machine bed.
The meat compartment of the machine length 400 mm.
Red material was used in the machine bed knife.
There are emergency stop button on the machine for emergencies.
There are 304 stainless length cutting blade on the machine.
The length of the cutting blade can be removed and machine can be made if you wish to cut the rectangle.
You will use the piston and speed settings on the machine hard-body size of vegetables can be adjusted according to the desired length.
Your machine will be cut by staying off work due to health and safety in mind upper push rod cover and the front cover is opened where the blade system if the electricity from the machine will be showcased in a special operation. When the lid is closed reservoir lid and front blade will continue to run from where it left the machine.
The first processing power cord plug to the switch before starting the machine by inserting one (1) is brought into position. Watch the upper chamber had done after the installation of your machine will automatically start working when the top cover is closed.
The push rod in the first installation process made the meat is stopped at the rear position, the push rod after the top cover is closed automatically start the printing process forward. Thanks to the pre-arranged quickly came to the rearmost position the power is supplied via magnetic eye after moving to the material in the hopper front cutter knife. When the installation is continued again by opening the top cover all the shooting process had completed the switch to 0 (zero) is brought into position. And thus it made ready for cleaning cutting off the electrical connection.
Capacity min / 5 kg